Design and simulation of wireless power transfer for electric vehicle matlab simulink

Project Objective

The objective of this project is to model, simulate and analyze Design and simulation of wireless power transfer for electric vehicle matlab simulink for advanced engineering research. The workflow is suitable for PhD scholars, postgraduate researchers and university students who need a clear simulation-oriented implementation with explainable outputs.

Simulation Methodology

• Define the research problem, system parameters and expected performance indicators.
• Develop the simulation architecture using MATLAB, Simulink.
• Implement the control, optimization, signal processing, AI or multiphysics logic required by the topic.
• Validate results using waveform analysis, comparative plots, steady-state/transient response and performance metrics.
• Document the block diagram, equations, assumptions, model settings and result explanation for thesis usage.

Expected Outputs

Typical outputs may include voltage/current waveforms, speed/torque response, power flow, SOC/SOH curves, control error, convergence plots, fault response, efficiency, THD, BER, radiation pattern, thermal distribution, pressure/stress field or classification accuracy depending on the topic.

Applications

This research topic is applicable to Electronics & Communication Engineering, Electric Vehicles & Battery Technology, model-based design, advanced simulation studies, thesis experimentation, journal-oriented validation and engineering education.

Keywords